Some booster kits, like the weBoost Home Room, consist of a stand-alone desktop antenna, while others, like the SureCall Flare 4G 3.0, or HiBoost Home 4K Plus, feature a 2-in-1 amplifier/antenna combo. Desktop Antenna: These antennas can be placed on any flat surface.Panel antennas distribute a single in a 45 to 70-degree angle, meaning the signal will be strongest in the areas closest to it. Panel Antenna: Usually, this antenna is wall-mounted, but it can also be ceiling mounted (make sure it’s facing down).Dome Antenna: This antenna is ceiling mounted and will distribute a signal in a 360-degree angle.Cell phone signal booster kits can consist of different types of indoor antennas: Ideally, the inside antenna should be installed in or near the area where you are experiencing connectivity issues. Once the cable is inside, connect it to the signal amplifier. A drip loop is a low point or a loop on the cable forcing the water to drip off and preventing it from entering your home. Whichever method you decide to use, it’s recommended to put a drip loop in your cable before it enters the house. Use a flat window entry cable and run it underneath the window.Following your satellite TV antenna cable and running the coax cable alongside it and into your house.Step 3: Connecting the Outdoor Antenna to the AmplifierĪfter the antenna has been installed, connect the coaxial cable that was included in the box to the antenna and run it inside your home. As a result, the amplifier will be receiving less signal, which can reduce the coverage area. Keep in mind that the added obstructions can degrade the signal the antenna will be receiving. In situations where installing the antenna on the roof is impractical, you can mount it in the attic, on a wall, or near a window facing the cell tower. There is no need to aim an omnidirectional antenna. If you’re using a directional antenna, such as a yagi antenna, make sure to point it away from your roof and in the direction of the nearest cell tower provided by your carrier. It’s recommended to place the antenna on or near the edge of the roof. This is where the ladder, Philips-head screwdriver, and adjustable wrench will come in handy. You can use a mounting pole, a vent pipe, or fascia to mount the antenna. Doing so will improve the antenna's line of sight with the cell phone tower, as well as reduce the number of obstacles between the antenna and the tower that can degrade the signal. The outdoor antenna (also known as a donor antenna) should be installed as high as possible, ideally on the roof of your house.
0 Comments
Leave a Reply. |